Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 649

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Telephones
MLX Port Module Contains Firmware Vintage 29
CTI Link Extensions:
Extension xxxx Failed.
MLX Port Module Contains
Firmware Vintage 29.
Exit
This message appears when the port that you are programming as the CTI Link is
on an MLX module with firmware vintage 29. Modules with this firmware vintage
do not work correctly with the CTI Link. You must either choose a port on a board
with firmware vintage other than 29 or replace the module with a module that has
a firmware vintage other than 29.
Port Reserved for Operator Positions
CTI Link Extensions:
Extension xxxx Failed.
This Port is Reserved
For Operator Positions.
Exit
This message appears when the port that you are programming as the CTI Link is
on the Operator Position list (as a QCC or DLC). Check your printout of the
Operator Infomation Report for programmed operator positions.
Extensions Covered by Extension
CTI Link Extension: xxxx
added, but it has.
primary or secondary
cover buttons at other
extensions.
Please remove them.
Exit
This message appears when the port that you are programming as the CTI Link is
covered by other extensions. You should remove the cover buttons on these
extensions.
Issue 1
June 1997
Page 4-242
4
4
4