Pri Facilities - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures

PRI Facilities

Console Display/Instructions
Return to the System Programming menu.

Select twice.
Exit
PRI Facilities
The procedures in this section provide the steps for programming the following
options for Primary Rate Interface (PRI) facilities connected to a 100D (DS1)
module:
Switch Type
Telephone Number
B-Channel Groups
Network Service
Copy Telephone Number to Send
Incoming Routing
Telephone Number to Send
Test Telephone Number
Timers and Counters
Terminal Equipment Identifier
Dial Plan Routing
Outgoing Tables
Network Selection Tables
Special Services Tables
Call-by-Call Service Table
NOTE: NOTE: NOTE:
If you are adding PRI facilities to an existing system, certain values must be
set correctly. To inspect or change these values, see
not start these procedures until you have checked the following:
Type of DS1 Facility must be set to PRI.
Frame format must be specified correctly.
Zero code suppression must be specified correctly.
Clock synchronization source must be set to loop (derived from the
T1 line).
Additional Information
4
Issue 1
June 1997
Page 4-143
PC
''DS1 Facilities''. Do