Programming Procedures; Introduction; Basic System Operating Conditions - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4

Programming Procedures

Introduction

Programming Procedures
0
Introduction
This chapter contains procedures for all of the advanced programming features
and options available on the System Programming menu, where each of the
procedures begins. It also contains summary information for all of the common
programming features described in detail in
Procedures''. Use one of the methods shown below to display the System
Programming menu.
At the console: Menu
At the PC or with SPM: Type
Before you begin any of the procedures in this chapter, you should read and
understand all of the information presented in

Basic System Operating Conditions

The procedures in this section are all related to the system rather than to the
operation of telephones, operator positions, lines, or trunks. These are operating
conditions that must be set only once, when the system is new, or when you reset
the system defaults.
NOTE: NOTE: NOTE:
You must reset the system time when Daylight Savings Time begins and
ends.
This section contains the following programming procedures:
System Restart
Board Renumbering
Mode of Operation
Automatic Maintenance Busy
4
Chapter 3, ''Common Administrative
Sys Program Exit
Press any key
spm
Chapter 1, ''Programming Basics''
4
Issue 1
June 1997
Page 4-1
4
.