Access To Centralized Telephone Programming - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
5 Centralized Telephone Programming

Access to Centralized Telephone Programming

To perform centralized telephone programming, you can use the system
programming console (see
software (see
In Release 2.0 and higher, if you are programming several telephones of the
same type (that is, all analog or all MLX), program one extension and then use the
programmed extension as a template for programming additional extensions. See
''Copy Extension''
Some programming can be performed only when the entire system or some part
of it (such as a trunk or an extension) is idle. See
Access to Centralized Telephone
Programming
Access the Centralized Programming menu from the System Programming menu.
Centralized programming is performed by selecting features from the display or
by using programming codes.
Follow the procedure below to access the Centralized Programming menu.
Console Display/Instructions
!
CAUTION:
Go to the second screen of the System Programming menu.
System Programming:
Make a Selection
System
SysRenumber
Operator
LinesTrunks
Exit
Select Centralized Programming.

System Programming
Make a selection
Labeling
Data
Print
Cntr-Prg
_
Exit
Chapter 1, ''Programming
Chapter 2, ''Programming with
and also refer to the planning forms.
Additional Information
>
Extensions
Options
Tables
AuxEquip
Press More.
NightSrvce
Basics'') or a PC with SPM
SPM'').
''Idle States'' in Chapter
5
Issue 1
June 1997
Page 5-2
1.
PC
U