Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 90

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Installing the SPM Software
If you typed
instal95
detected, you see an error message that tells you to run the Instal95
program.
Creates the directory c:\spm if it does not already exist.
Checks if the print.exe file is present in any directory listed in the PATH
environment variable.
Runs the DOS SETVER command to set the version table for print.exe to
6.22. This is required to enable print.exe to run on Windows 95.
Creates an spm.bat file in the directory c:\spm. The spm.bat file contains
the ams_path and print statements required to run SPM.
Unzips and copies the remaining files into the directory c:\spm.
Instructs you to refer to this document for details on using the PIF Editor to
configure an SPM PIF file to work with the spm.exe file.
Installation
With Windows 95 running on your PC, follow these steps to install SPM on the
PC's hard drive:
1. Insert a backup copy of SPM in any floppy disk drive (usually the A drive).
2. Choose one of the following two methods to install SPM:
Method 1- Install DOS SPM with French, Spanish, or English
Language:
a.
b.
c.
Method 2- Install DOS SPM with French, Spanish, or English
Language:
(the command for DOS installation) instead of
install
, checks if your PC has Windows 95 installed. If Windows 95 is
Open a DOS Window from the Windows Explorer.
At the DOS prompt, switch to the drive with the backup copy of SPM
diskette (usually the A drive).
At the DOS prompt, type one of the commands shown below and
press .
instal95 or instal95 english
instal95 french
instal95 spanish
NOTE:
Because English is the factory-set language,
have the same result. If you do use the language
instal95 english
argument ( ,
english
lowercase letters as shown. The command
uppercase or lowercase letters.
2
or ), you must type it in
french spanish
Issue 1
June 1997
Page 2-6
and
instal95
may be in
instal95