Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 426

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
System Renumbering
Console/Display Instructions
Select the type of extension to renumber.

System Renumber:
Make a selection
Default Numbering
Single
Block
Exit
Return to the System Programming menu.

Select twice.
Exit
Single Renumbering
Use this procedure to assign a specified extension number to a telephone,
accessory, line, pool (Hybrid/PBX only), calling group, paging group, or Listed
Directory Number. Single renumbering is also used for Remote Access, Park, Idle
Line Access (Key and Behind Switch only), and Automatic Route Selection
(Hybrid/PBX only).
See Chapter 3, ''Common Administrative Procedures''
!
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
Summary: Single Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Additional Information
To change individual extension numbers,
select
Renumbering."
To change a block of extension numbers,
select
Renumbering."
CAUTION:
Select on the console or
Exit
extensions. If you press Home, extensions may remain in the forced
idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
System Manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
and go to "Single
Single
and go to "Block
Block
4
for detailed information.
on the PC after renumbering
4
Issue 1
June 1997
Page 4-19
PC