Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 111

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Using SPM
Type the new filename and press

Press ESC to Abort.
Enter filename:
(default is backup.ams)
You can specify a drive letter with the filename but no path information.
Verify that the filename chosen does not already exist.

The following screen appears only if the filename chosen already exists. Continue
with Step 7
The file already exists.
If you continue, the old
version will be deleted.
Press ESC to abort.
or c to continue.
Observe the backup status screen.

Press ESC to Abort.
Est. Blocks: xxx - xxxx
filename
BACKUP IN PROGRESS
Received Block xx
SPM indicates the status of the backup by displaying the number of the last block
received (
to be sent from the control unit (
up from Release 1.0.
If you abort the backup, the partial backup file is deleted to prevent restoration
from a corrupted file and you see the screen shown in Step 8.
When the backup is complete, you see the screen shown in Step 9.
if this screen does not appear.
). Line 2 of the display screen shows the estimated number of blocks
xx
.
If you are working from the floppy drive,
appears on the screen.
A:\
Press to abort the backup. Go to
Step 1 to create a different backup file.
Press to continue. Go to Step 7.
filename = the backup filename specified
in Step 5
). This line is blank if you are backing
xxx-xxxx
Issue 1
June 1997
Page 2-27