Hold Disconnect Interval - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Return to the System Programming menu.

Select three times.
Exit

Hold Disconnect Interval

Use this procedure to specify the number of milliseconds before a loop-start
line/trunk is released when a caller on hold hangs up and abandons the call. This
can be specified as either a long interval (450 ms) or a short interval (50 ms). The
hold disconnect interval applies to loop-start trunks connected to 400, 408, or 800
modules; it does not apply to emulated loop-start trunks (T1 facility).
NOTES:
1. If the disconnect interval is longer than the telephone company setting,
2. Do not program a short interval unless the local telephone company's
3. Do not program a reliable disconnect for lines/trunks with a short hold
For more information on Hold Interval Disconnect and Reliable and Unreliable
Disconnect, see the Feature Reference.
Summary: Hold Disconnect Interval
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
the line is not released when a caller on hold hangs up.
central office is the crossbar type.
disconnect interval. This can cause active calls as well as lines/trunks on
hold to be disconnected. See
System Manager
All
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Long interval (450 ms)
Long interval, Short interval
No
No
LinesTrunks
mode Dial no. of the line/trunk
To program a block of lines/trunks:
LinesTrunks
lines/trunks
Additional Information
4
''Disconnect Signaling
4
More
HoldDiscnct
More
HoldDiscnct
Toggle LED On/Off
Issue 1
June 1997
Page 4-43
Reliability''.
Select entry
Enter Exit Exit
Select block of
Enter Exit Exit
PC