Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 459

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit
Block Procedure
Console Display/Instructions
Specify the block of 20 lines associated with the 20 line buttons on the system

programming console.
Select
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Assign the queue priority specified.

Return to the System Programming menu.

Select twice.
Exit
QCC Operator to Receive Calls
Use this procedure to specify whether or not incoming calls on each line/trunk ring
into the QCC queue and to identify the QCC system operator positions that
receive incoming calls on each line/trunk.
NOTES:
1. This procedure applies to Hybrid/PBX mode only in a system that
2. Each ground-start, loop-start, or automatic-in tie trunk programmed to
includes QCC operator positions.
ring into the QCC queue can be associated with one or more QCC
operator positions.
Additional Information
Additional Information
Toggle the green LED on or off as required.
On = to assign the queue priority
Off = not to assign the queue priority
4
Issue 1
June 1997
Page 4-52
PC
PC