Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 411

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Basic System Operating Conditions
System Programming Position Assignment
Use this procedure to reassign the extension used for system programming. This
extension should not be the same extension as that used for the operator position.
The system programming position can be reassigned only to one of the first five
extension jacks on the first MLX module. Only one system programming console
is allowed per system.
If you are programming on the console, be aware of the following:
The console must be connected to the extension currently assigned for
system programming.
As soon as you change the system programming extension, the system
programming session is terminated. To proceed with system programming,
you must connect the system programming console to the newly assigned
extension and enter system programming again.
NOTE: NOTE: NOTE:
The telephone used for system programming must be an MLX-20L.
See Chapter 3, ''Common Administrative Procedures''
Summary: System Programming Position
Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Manager
All
Not required
Form 1, System Planning
First extension jack on the first MLX module (also set as an
operator position)
Extension number of one of the first five extension jacks on
the first MLX module
No
No
System SProg Port
+
4
for detailed information.
4
Drop Dial ext. no.
Type ext. no.
Issue 1
June 1997
Page 4-4
Enter Exit