Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 625

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Telephones
Broadcast Music Incorporated). Magic on Hold requires no such license and can
be purchased from Lucent Technologies.
Pool buttons cannot be assigned to or removed from extensions unless the pool
has trunks assigned. If all trunks are to be removed from a pool, all Pool button
assignments must first be removed from telephones. Another way of handling this
situation is to program another trunk into the pool and then remove the Pool
button assignments from the extensions.
Hybrid/PBX only. Individual lines/trunks assigned to a pool can be
assigned to a button only on a DLC operator position. If one of the
lines/trunks in a pool is assigned to a button on a non-DLC telephone, the
result is a Pool button assignment.
Key only. The system assigns the first eight line numbers to buttons on
multiline telephones whether or not an outside line is physically connected.
If a line is not connected, the button assignment must be removed so the
user can assign a feature to the button.
For the MDC 9000 and MLC-5 cordless multiline telephones and the
MDW 9000 wireless multiline telephone, the system assigns the first eight
lines connected to the control unit even though the telephone has fewer
than eight buttons available. Remove the extra lines in system
programming so that the appropriate number of lines is assigned to buttons
on these telephones.
Lines and trunks are assigned to buttons in the order in which you press each line
button on the system programming console or keyboard. Existing line
assignments can be rearranged by removing all current assignments and then
pressing the line buttons on the console or keyboard in the order in which they
should appear on the buttons. For information on the order of the programmed
buttons, refer to the button numbers on the applicable planning form for each
telephone.
If you want to reserve some blank buttons for features between line buttons, a line
must be assigned as a placeholder for each blank button. After all lines are
assigned, remove the lines used as placeholders on the buttons reserved for
features.
Summary: Assign Trunks or Pools to Telephones
Programmable by
Mode
Idle Condition
Planning Form
System Manager
All, but note differences in factory settings
Telephone idle
Form 4b, Analog Multiline Telephone
Form 4d, MLX Telephone
Form 4e, MFM Adjunct: MLX Telephone
Form 4f, Tip/Ring Equipment
Form 5a, Direct-Line Console (DLC): Analog
Form 5b, Direct-Line Console (DLC): Digital
4
Issue 1
June 1997
Page 4-218