Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 514

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Tie Trunks
Specify the trunk direction.

Trunk xxxx :
Select trunk direction
Two Way
_
OutGoing
_
InComing
_
Exit
Continue to assign the direction to another trunk or go to Step 8.

Select .
Next
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit
Tie Trunk Seizure Type
Use this procedure to specify whether the seizure type of incoming or outgoing tie
trunk is wink, delay, immediate, or automatic.
The following settings are recommended when T1 facilities are programmed for
tie-trunk emulation to provide special network services [such as Megacom,
Megacom 800, or Software Defined Network (SDN)]:
If Automatic Route Selection (ARS) is used for all outgoing calls and no
personal line or Pool buttons are used, assign the wink signaling type. Set
the network to wink.
If personal line or Pool buttons (pool or dial-out codes) are used for
outgoing calls, assign the immediate signaling type. Set the network to dial.
Contact your service provider for more information about the dial setting.
If Dialed Number Identification Service (DNIS) is used for incoming calls,
assign the wink signaling type. The network is also set to wink. (Setting
both ends to immediate also works.) Contact your service provider for more
information about the appropriate setting.
When DNIS is not used for incoming calls, assign the automatic signaling
type. The network is set to automatic.
xxxx = trunk entered in Step 4
OutGoing
Next
InComing
Enter
Select ,
Two Way
, or
.
Return to Step 6. The next trunk will be
displayed on Line 1.
4
Issue 1
June 1997
Page 4-107