Telephone Programming - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
D General Feature Use and Telephone Programming

Telephone Programming

Telephone Programming
The following describes how to program features on MLX and analog multiline
telephones. Since Personal Speed Dial is the only feature that single-line
telephone users can program, general programming instructions for single-line
telephones are not provided.
NOTE:
Features cannot be programmed on QCCs in system operator positions.
Features assigned to these consoles are fixed and cannot be changed.
Programming Methods
Telephones can be programmed by dialing programming codes or on MLX
display phones by selecting features from the display. An analog multiline
telephone cannot be programmed by selecting features from the display.
To program a telephone, first enter programming mode:
On analog multiline telephones, slide the Test/Program (T/P) switch on the
side of the telephone to P.
On MLX-10 telephones, press the Feature button and dial
On MLX display telephones, use the same procedures as the MLX-10 or
enter programming mode by selecting
the display.
See the appropriate user or operator guide for more information.
NOTE:
Features can also be programmed onto individual telephones through
Centralized Telephone Programming. The steps for using programming
codes vary depending on the telephone. Tables D–2 through D–4 list the
basic steps for programming each telephone type.
D
D
00
from the menu screen on
Ext Program
Issue 1
June 1997
Page D-12
.