Surrogate Mode Programming - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance

Surrogate Mode Programming

Feature
Surrogate Mode Programming
Surrogate mode allows qualified service personnel to perform system
programming at an off-site service location. The actual communications system
hardware does not have to be installed—the programmer needs only a direct
connection from the PC to the processor module. By following a customer's set
of completed planning forms, the system can be programmed as if the
appropriate modules, trunks, and telephones have been installed. When
system programming is completed, a system backup is performed to save the
Sequence
Dial ext. no.
,
starting number
Enter trunk number
switch number
Enter starting number
ending trunk
Enter trunk number
,
Select
or
More More
Select
, or
Enter ending number
More
More
Enter switch number
More
Select
, , or
Issue 1
February 1998
Page 91
Enter
Enter
Enter
(Select