Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 684

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
System Features
Copy Option
Console Procedure
PC Procedure
One-Touch Transfer/One-Touch Hold
Use this procedure to assign either the One-Touch Transfer or One-Touch Hold
feature.
One-Touch Transfer allows users to initiate transfers to another extension by
pressing an Auto Dial or DSS button for that extension. If the One-Touch Transfer
feature is assigned, you must also specify whether the transfer completion is
manual (the user has to press another button to complete the transfer) or
automatic (the transfer is completed automatically).
The One-Touch Transfer feature is not available on single-line telephones.
One-Touch Hold applies to incoming central office calls only. When the user
presses an Auto Dial or DSS button to initiate a transfer, the outside caller is put
on hold. The system automatically selects an intercom facility and dials the
transfer destination. There is no transfer return function with this method.
Consequently, if the transfer destination does not answer or is busy, the user who
initiates the transfer must notify the outside caller, or the outside caller will remain
on hold.
One-Touch Hold is the factory setting in Behind Switch mode only.
Summary: One-Touch Transfer/Hold
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
No
Options Transfer
rings
Enter Exit
rings
System Manager
All
Not required
Form 8a, System Features
One-Touch Transfer, automatic completion (One-Touch Hold
is the factory setting in Behind Switch mode.)
Transfer, Hold
No
No
Drop
Return Time
Exit
+ Type no. of
4
4
Issue 1
June 1997
Page 4-277
Dial no. of