Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 213

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
Telephones
Block Procedure
Console Display/Instructions
Specify the block of 20 lines associated with 20 buttons

on the system programming console.
Select
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Assign or remove the line/trunk to or from the line button.

Save your entry.

Select .
Enter
Return to the System Programming menu.

Select two times.
Exit
Copy Line/Trunk Assignments
Use this procedure to copy outside line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and (for operator positions only) Night
Service information from one extension to another extension or block of
extensions with identical requirements.
If you are copying assignments to a block of extensions and one of the extensions
in the block is in use, the display shows the
Copying for the rest of the extensions in the block is delayed until the busy
extension becomes idle. The number of the busy extension is not shown. If a
DSS is attached, the LED associated with the busy extension is on. If you exit
instead of waiting for the busy extension to become idle, copying for the rest of the
extensions is canceled; however, the assignments that have already been copied
are not canceled.
Additional Information
.
Toggle the green LEDs next to each
line button on or off as required.
On = line/trunk or pool assigned to
extension
Off = line/trunk or pool not assigned to
extension
For Hybrid/PBX only:
The red LED indicates:
On = trunk assigned to pool
Off = trunk not assigned to pool
3
Station Busy - Pls Wait
Issue 1
June 1997
Page 3-59
PC
message.