Automatic Route Selection; Not Within Area Code - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures

Automatic Route Selection

Console Display/Instructions
Return to the System Programming menu.

Select three times.
Exit
Automatic Route Selection
This section contains programming procedures for the following Automatic Route
Selection (ARS) features:
1 + 7-Digit Dialing Requirements
ARS Tables
Start and Stop Times for Subpatterns
Pool Routing
Facility Restriction Level (FRL)
Digit Absorption
Other Digits
N11 Special Numbers Tables
Dial 0 Table
Voice and/or Data Routing
NOTE: NOTE: NOTE:
ARS applies to Hybrid/PBX mode only.
1 + 7-Digit Dialing Requirements
Use this procedure for calls placed within the same (home) area code as the
system. The procedure allows you to specify whether or not the local telephone
company requires a 1 to precede the 7-digit number. The two available settings
are:
Within Area Code. Requires that a 1 plus a 7-digit number must be dialed;
the system checks the 1 + 7-digit tables for routing.
Not Within Area Code. Does not require that a 1 precede the 7-digit
number (the system does this automatically).
Summary: 1 + 7-Digit Dialing Requirements
Programmable by
Mode
Idle Condition
Planning Form
Additional Information
System Manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
4
4
4
Issue 1
June 1997
Page 4-315
PC