Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 705

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
System Features
Remote Access Without Barrier Codes
Use this procedure to change the class of restriction for one of the following:
All non-tie lines/trunks
All tie trunks and DID trunks with Remote Access
DID remote access code
!
SecurityAlert:
Your system will be highly susceptible to toll fraud if you activate the Remote
Access feature without barrier codes. Lucent Technologies does not
recommend doing this.
NOTE: NOTE: NOTE:
If barrier code requirements have been established for remote access
users, use "Remote Access with Barrier Codes" and not this procedure.
The class of restriction assigned may be one of the following:
Restriction. Determines whether remote access users can make local
and/or toll calls and includes the following settings:
ARS Facility Restriction Level (Hybrid/PBX only). Allows or disallows use of
outgoing trunks by assigning a facility restriction level from 0 through 6.
The FRL ranges from 0 (most restrictive) to 6 (least restrictive). The FRL
value assigned here is the opposite of the FRL value assigned to the ARS
route, where a value of 0 is the least restrictive and a value of 6 is the most
restrictive.
Allowed Lists Assignment. Assigns Allowed Lists and is used when remote
access users are restricted from making local or toll calls.
Disallowed Lists Assignment. Assigns Disallowed Lists and is used when
remote access users are not restricted from making local or toll calls.
A maximum of eight Allowed or Disallowed Lists can be assigned to lines/trunks.
Class of restriction settings are assigned either to all non-tie trunks or to all tie
trunks and DID trunks. They cannot be assigned to each trunk on an individual
basis.
— Unrestricted
— Toll restricted
— Outward restricted
4
Issue 1
June 1997
Page 4-298