Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 456

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit
QCC Queue Priority Level
Use this procedure to assign QCC queue priority level values (1 to 7) to each
loop-start, ground-start, and automatic-in tie trunk in your system. The value
assigned determines the order in which calls are sent to the QCC operator
positions. Call priority 1 is the highest priority, and 7 is the lowest priority.
NOTE: NOTE: NOTE:
This procedure applies to Hybrid/PBX mode only in a system that includes
QCC operator positions.
Summary: QCC Queue Priority Level
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
Additional Information
System Manager
Hybrid/PBX
Not required
Form 2c, System Numbering: Line/Trunk Jacks
4
1 to 7
Yes
No
More
LinesTrunks
level Select entry mode
Enter
no.
Enter Exit
To program a block of lines/trunks:
More
LinesTrunks
level Select block of lines
Enter
On/Off
Enter Exit
4
4
Dial priority
QCC Prior
Dial trunk
Exit
Dial priority
QCC Prior
Toggle LED
Exit
Issue 1
June 1997
Page 4-49
PC