Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 176

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
System Operator Positions
Console Display/Instructions
Assign or remove the QCC operator extension.

Select
Enter
.
Delete
Indicate that you have finished entering all positions.

Select
Store All
DLC Operator Positions
DLC operator positions can be assigned to the first and fifth extension jacks on
the first modules with either digital or analog multiline extension jacks. A
maximum of eight DLC operator positions can be assigned. Any combination of
operator positions can be assigned as long as there are no more than four QCC
operator positions and no more than a total of eight operator positions.
Use this procedure to specify extensions that serve as central answering positions
for all incoming calls,either for Call Management Systems (CMSs) connected to
operator extension jacks, or as calling group supervisor extensions. (You do not
need to use this procedure in a Key or Behind Switch system unless you have
more than one DLC position.) For a new system, remove the factory-set DLC
operator position assignment for any telephone not used as an operator position.
Lines and trunks are assigned to individual buttons.
The system programming console can have several incoming calls ringing
simultaneously.
Each CMS requires two DLC operator positions to connect the equipment and
one position to serve as CMS supervisor.
Summary: Identify or Remove DLC Operator
Positions
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
or
.
System Manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Type: DLC
Additional Information
You may continue to assign or remove
QCC operator positions by repeating
Steps 4 and 5.
The session is terminated and the sys-
tem restarts. You must enter system pro-
gramming again to continue.
3
3
Issue 1
June 1997
Page 3-22
PC