Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 629

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Telephones
Assign Intercom or System Access Buttons
Use this procedure to assign or change the assignments for Intercom (ICOM)
buttons used to make and receive inside calls. This includes the following types of
Intercom buttons:
Ring
Voice
Originate Only (Ring or Voice)
In Hybrid/PBX mode only, use this procedure to assign or change assignments for
System Access (SA) buttons used to make or receive inside and outside calls.
This procedure includes the following types of System Access buttons:
Ring
Voice
Originate Only (Ring or Voice)
Shared (Ring or Voice)
NOTES:
1.You cannot change the factory setting for Call buttons assigned to QCC
operator positions, and you cannot assign Ring, Voice, Originate Only, or
Shared buttons to QCC operator positions.
2.System Access or Intercom buttons can be assigned to only the first 10
buttons on a telephone.
3.You can assign a combination of up to 10 System Access or Intercom
buttons to each telephone (excluding QCC operator positions).
4.You can remove System Access or Intercom buttons, but at least one
must remain on the telephone.
5.Each System Access Ring or Voice on an individual telephone can be
assigned as a Shared System Access (SSA) button on up to 16 other
telephones.
Release 3.0 and later
Each System Access Ring or Voice on an individual telephone can be
assigned as a Shared System Access (SSA) button on up to 27 other
telephones.
6.System Access and Intercom buttons are centrally programmed and
cannot be programmed by individual telephone users.
4
Issue 1
June 1997
Page 4-222