Programming The System - Lucent Technologies MERLIN LEGEND Release 6.0 Installation Manual

MERLIN LEGEND Communications System Release 6.0
Installation 555-660-140
Introduction

Programming the System

Connecting the Network Interface
The following forms indicate the trunks that you must connect to the control unit.
Information regarding the channel service unit (CSU) is included on these
forms.
Form 2c, System Numbering: Line/Trunk Jacks
Form 3a, Incoming Trunks: Remote Access
Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
Form 3d, Incoming Trunks: DID
Connecting Data Equipment
The following forms indicate the data equipment you will need to set up data
stations.
Data Form 1a, Modem Data Station
Data Form1b, 7500B Data Station
Data Form 2, Data Hunt Groups
Programming the System
If you have a system programming disk created with SPM or a Translation
memory card, you do not need to program the system. Instead, you can use the
disk or memory card to restore the system; see Chapter 7, "Initializing and
Testing the System," for instructions. If you did not receive a disk or a memory
card and it is your responsibility to program the system, see System
Programming for instructions.
Issue 1
February 1998
Page 1-4