Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 462

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Specify the line(s) associated

with the QCC operator.
QCC Operator xxxx :
Enter line/trunk number
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Exit
Single Line Procedure
Specify entry mode.

Select
Entry Mode
Enter the line/trunk assigned to ring into the QCC queue.

QCC Operator xxxx :
Enter line/trunk number
Backspace
Exit
Assign or remove the line/trunk from the specified QCC operator.

Select
Enter
Delete
Continue to assign line/trunk to another QCC operator or go to Step 5.

Select .
Next
Return to the System Programming menu.

Select twice.
Exit
Entry Mode
.
Delete
Next
Enter
or
.
Additional Information
xxxx = extension number entered in Step 4
For a single line/trunk, go to
Single Line Procedure.
For a block of lines/trunks, go to
Block Procedure.
xxxx = extension number entered in
Step 4
Dial or type:
Trunk number [ nnn ]
Slot and port number
Logical ID number
#
You may continue to assign or remove additional
lines/trunks from the QCC operator by repeating
Steps 2 and 3.
Return to Step 2. The next QCC operator
will be displayed on Line 1.
June 1997
Page 4-55
[ sspp ]
*
[ nnn ]
Issue 1
PC
Ã