Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 476

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
NOTES:
1.You can copy options to a block of lines/trunks only if they are all the
same type (loop-start, ground-start, Tie, or DID). If you attempt to copy
assignments and there is a mismatch in line/trunk type, information is
copied to that point only. You receive no error message.
2.If you are copying options to a block of lines/trunks, they must be
sequentially numbered.
3.If the block you are copying to includes an invalid line/trunk type, the
copying process stops at the invalid type. Only the lines/trunks that were
copied to before the invalid type was found are copied successfully.
4.If you are copying assignments to a block of lines/trunks and one of the
lines or trunks is in use, you see the message
on your display. The copying for the rest of the lines/trunks in the block is
delayed until the busy line/trunk becomes idle. If you exit without waiting
for the copying to complete, the copying done up to that point is not
canceled.
Summary: Copy Options for Lines/Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To copy individual lines/trunks:
System Manager
All (but note differences)
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Form 3c, Incoming Trunks: TIE
Form 3d, Incoming Trunks: DID
Not applicable
Not applicable
No
Not applicable
LinesTrunks Copy
no. Dial copy to trunk
Enter
no.
Enter Exit
To copy blocks of lines/trunks:
LinesTrunks Copy
no. Dial first copy to trunk no. in
Enter
block Dial last copy to trunk no. in
Enter
block
Enter Exit
Trunk Busy - Pls wait
4
Dial copy from trunk
Single
Exit Exit
Dial copy from trunk
Block
Exit Exit
Issue 1
June 1997
Page 4-69