Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 401

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
Memory Card
While the backup is in progress, you cannot access system programming
functions, your Personal Directory, or alarm clock functions (any programmed
alarms are temporarily deactivated).
If any type of programming is taking place at an extension during the automatic
backup procedure, the backup is canceled. The system does not re-attempt the
backup.
If an automatic backup fails for any reason (including a system-busy condition), all
of the programmed alarm buttons on system operator consoles light and the
information is recorded in both the permanent error log and the last 10 error logs.
The system does not re-attempt the backup.
Also see ''Backup Messages''
the automatic backup procedure.
NOTE: NOTE: NOTE:
If an automatic backup fails for any reason (except when the failure results
because the memory card is write-protected) the automatic backup feature
is turned off. Follow the procedure below to reprogram automatic backups.
Summary: Automatic Backup
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program daily backup:
for information about errors that may occur during
System Manager
All
Not required (No extensions are allowed to be in
programming mode including the system programming
console)
Form 1, System Planning
Weekly backup: Sunday at 2:00 am
(if daily backup is selected, time is factory set for 2:00 am)
Daily: hhmm (00 to 23; 00 to 59)
Weekly: dhhmm (0 to 6; 00 to 23; 00 to 59)
No
No
Insert memory card
Auto Backup Daily
Exit Exit
To program weekly backup:
Insert memory card
Auto Backup Weekly
Enter Exit Exit
3
System Back/Restore
Drop Dial time
System Back/Restore
Drop Dial day and time
Issue 1
June 1997
Page 3-247
Enter