Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 263

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
Optional Telephone Features
Console/Display Instructions
Select Trunk to Trunk Transfer.

Extensions:
Make a selection
TrkTransfer
_
HotLine
Exit
Specify the extension.

Trunk to Trunk Transfer:
Enter extension
Backspace
Exit
Assign or remove trunk-to-trunk transfer from the extension entered in Step 4.

Select
Enter
Delete
Return to the System Programming menu.

Select twice.
Exit
HotLine
Use this procedure to enable or disable the HotLine feature on a single-line
telephone set or device.
Summary: HotLine
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
>
Delete
Enter
to allow trunk-to-trunk transfer or
to disallow trunk-to-trunk transfer.
System Manager
All
Not required
Form 4f, Tip/Ring Equipment
Disabled
Yes, No
No
Additional Information
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = trunk-to-trunk transfer is enabled.
Off = trunk-to-trunk transfer is disabled.
You may continue to assign or remove
trunk-to-trunk transfer from additional
extensions by repeating Steps 4 and 5.
3
3
Issue 1
June 1997
Page 3-109
PC