Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 170

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
System Renumbering
Console Display/Instructions
Save your entry.

Select
Enter
Next.
Return to the System Programming menu.

Select two times.
Exit
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
!
Summary: Block Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
or
CAUTION:
Select on the console or
Exit
renumbering extensions. If you press Home, extensions may remain
in the forced idle condition (indicated when the LED next to each DSS
button is on). To restore extensions to their normal operating state,
restart the system.
System Manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
Yes
Yes
Additional Information
If you use to renumber the next
Next
item (****) displayed on Line 1, return
to Step 7.
3
on the PC when you have finished
3
Issue 1
June 1997
Page 3-16
PC