Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 475

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Return to the System Programming menu.

Select twice.
Exit
Block Procedure
Console Display/Instructions
Specify the block of 20 lines associated with the 20 line buttons

on the system programming console.
Select
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Assign the appropriate lines/trunks to the pool.

Return to the System Programming menu.

Select twice.
Exit
Copy Options for Lines/Trunks
Use this procedure to copy options assigned to loop-start or ground-start trunks,
Tie trunks, or DID trunks. Note that many of these options apply to Hybrid/PBX
systems only. The following information is copied for each line/trunk type:
Loop-Start or Ground-Start Trunks (including those emulated on T1
facilities). Toll type, signaling type, and trunk pool assignment (Hybrid/PBX
only).
Tie Trunks. Direction, Tie trunk type, E&M signal, dial mode, dial tone,
answer supervision time, disconnect time, and trunk pool assignment
(Hybrid/PBX only).
DID Trunks (Hybrid/PBX only). Block assignment and disconnect time.
To find out whether there is an optional feature assigned that you would like to
copy, use Inspct from the system programming console or
Additional Information
Additional Information
Toggle the red LED on or off as required.
On = trunk is assigned to specified pool
Off = trunk is not assigned to specified pool
4
Issue 1
June 1997
Page 4-68
PC
PC
on a PC.