Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 91

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Installing the SPM Software
a.
b.
3. After you start DOS SPM installation using either method, the following
message appears:
SPM WINDOWS 95 HARD DISK INSTALLATION PROGRAM
Press any key to continue.
4. Press any key to begin the installation.
5. If your PC does not have a copy of PRINT.EXE in any directory listed in
your system's PATH environment, the following message appears:
Copying print.exe to directory c:\spm
file(s) copied
WARNING - The application you are adding to the Windows
version table may not have been verified by Microsoft
in this version of Windows. Please contact your
software vendor for information on whether this
application will operate properly under this version of
Windows. If you execute this application by instructing
Windows to report a different MS-DOS version number,
you may lose or corrupt data, or cause system
instabilities. In that circumstance, Microsoft is not
responsible for any loss or damage.
Version table successfully updated.
The version change will take effect the next time you
restart your system.
*******************************************************
SPM Note: The warning message seen above was produced
by the SETVER command. This command was used in the SPM
install program to set the proper version of PRINT.EXE
file in the DOS version table. Please note that in
Windows 95, running SETVER always produces the warning
message seen above, even when the command is run
properly.
*******************************************************
Press any Key to continue . . .
6. Press any key to continue installation. When SPM installation is complete
the following message appears:
Installation of SPM for DOS on your Windows 95 hard
drive is now complete. For easy access to SPM from
Windows 95, configure an SPM.PIF file. See the SPM
Manual for details. Press any key to continue . . .
From the Windows Explorer, select the floppy drive that contains the
backup copy of SPM diskette.
Select and run Instal95 (either by double clicking on the file name or
single clicking on the file name and using the menu choice
File:Open).
Issue 1
June 1997
Page 2-7