B Data - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Data Features
Assign or remove the voice/data pair.

Select
Enter
Delete
Return to the System Programming menu.

Select .
Exit

2B Data

Use this procedure to program an MLX port for 2B Data capability. Assigning a
port for 2B Data allows both B-Channels of a single MLX port to be used for up to
128 Kbps data calls. 2B Data capability is available on in Release 4.0 and later.
Consider the following when programming ports for 2B Data capability:
The extension number of the port cannot be the first or fifth port on an MLX
module. These ports are designated as potential operator ports and cannot
be used for 2B Data connections.
The extension number must correspond to the adjunct extension number of
an MLX port. By default these extensions begin with "7."
Devices that are not intended for 2B Data should not be connected to a
port programmed for 2B Data. These devices probably will not work.
Summary: 2B Data
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
or
.
System Manager
Key, Hybrid/PBX
Required
Data Form 2b, Digital Data Station
None
Adjunct extension number up to four digits
Yes
No
Data 2B Data
 
no.
Enter
You may continue to assign or remove additional
voice/data pairs by repeating Steps 4 and 5.
4
4
Dial adjunct ext.
Exit Exit
Type adjunct ext. no.
Issue 1
June 1997
Page 4-362