Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 113

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Using SPM
empty slot. You must reseat all of the boards to fill the empty slot before you
perform the board renumber.
The Inspect function (
slots on the control unit. Note that both phantom boards and real boards display if
you use the Inspect function. To see only real board assignments, you must print
the System Information report:
System
Table 2-5
Table 2-5.
Board Type
400LSR
400GLR
800LS
800GLID
800GLS
408LSA
408GLA
408GLM
008ATL
008MLX
012TR/OPT
016TR
800DID
400E&M
100D
800BRI
Follow the steps below to assign modules.
) lets you see which modules have been assigned to
More
Print SysSet-up
shows the type of boards that you can select.
Board Types
Description
4 loop-start line jacks with 4 touch-tone receivers
4 ground-start/loop-start line jacks with 4 touch-tone receivers
8 loop-start line jacks
8 ground-start/loop-start line jacks with Caller ID capability
available on the loop-start lines and 2 touch-tone receivers
8 ground-start/loop-start line jacks
4 loop-start line jacks and 8 ATL analog extension jacks
4 ground-start/loop-start line jacks and 8 ATL analog extension
jacks
4 ground-start/loop-start line jacks and 8 MLX extension jacks
(16 endpoints)
8 analog extension jacks
8 MLX-20L extension jacks (16 endpoints)
12 tip/ring extension jacks with 2 touch-tone receivers or 008
OPT jacks
16 tip/ring extension jacks with 4 touch-tone receivers
8 DID trunk jacks with 2 touch-tone receivers
4 E&M tie trunk jacks
1 DS1 jack (24 channels)
8 BRI trunk jacks (16 channels)
.
Issue 1
June 1997
Page 2-29