Installing The Spm Software - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM

Installing the SPM Software

Modem (local or remote) connection
In addition, a parallel printer is useful for reports (the PC needs a parallel port for
the connection).
NOTE: NOTE: NOTE:
SPM uses Interrupt 4 and I/O address 3F8 for COM1. It uses Interrupt 3
and I/O address 2F8 for COM2.
Installing the SPM Software
Before you install or run SPM, use
system guide) to make a backup copy of the SPM diskette and store the original in
a safe place. Use the backup copy to run the installation program.
For installing SPM on a DOS PC, follow the appropriate instructions in the next
section of this book.
NOTE: NOTE: NOTE:
If your PC does not have a hard disk, you do not need to run the installation
program. Go to "Initializing the SPM Software."
DOS Installation
Use the following procedure to install SPM on the hard drive of a DOS PC.
NOTE: NOTE: NOTE:
If you are updating SPM, you do not need to remove the current SPM files.
The new files will overwrite your current SPM files.
Considerations
Review the following items before you begin the installation procedure.
— BR1A-4P adapter and either a 102 connecting block or 103
connecting block
— 248B adapter
— eight-position wall jacks
— four-pair plug-ended cable
— D8W cords
— D6AP power cord
— EIA-232-D cables
— A modem that supports 1200- or 2400-bps connections
2
on a DOS PC (see your operating
diskcopy
2
Issue 1
June 1997
Page 2-3
2