Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 427

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
System Renumbering
Inspect
Copy Option
Console Procedure
PC Procedure
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
See Chapter 3, ''Common Administrative Procedures''
!
Summary: Block Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
Yes
No
SysRenumber
no.
Enter
new ext. no.
CAUTION:
Select on the console or
Exit
renumbering extensions. If you press Home, extensions may remain
in the forced idle condition (indicated when the LED next to each DSS
button is on). To restore extensions to their normal operating state,
restart the system.
System Manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
Yes
Yes
SysRenumber
first group member
member
Enter
no.
Enter
Select item
Single
Dial new ext. no.
Select item Type old ext. no.
4
on the PC when you have finished
4
Select type of group
Block
Dial no. of last group
Enter
Dial new beginning
Exit Exit Exit
June 1997
Page 4-20
Dial old ext.
Enter Exit Exit
Type
for detailed information.
Dial no. of
Issue 1