Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 757

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Night Service
NOTE: NOTE: NOTE:
The current day of the week for Night Service must be reset if system
programming information is being loaded into memory from a backup.
Summary: Night Service with Time Set
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To add or change start/stop time:
PC Procedure
Night Service with Coverage Control
Use this procedure to enable or disable the Night Service Coverage Control
option to automatically control the status of programmed Coverage VMS Off
buttons.
When the Coverage Control option is enabled, a transition into Night Service
(either by pressing a Night Service button or automatically by the Time Set
option) automatically deactivates the VMS Coverage Off (Release 2.0 or later)
buttons (LED is off) and allows outside calls to go to VMS Coverage at night.
When the system is taken out of Night Service (either by pressing a Night
Service button or automatically by the Time Set option), programmed VMS
Coverage Off buttons are activated (LED is on) and outside calls are prevented
from going to VMS Coverage during the day.
System Manager
All
Not required
Form 9c, Night Service: Time Set
Not applicable
Day: 0 to 6; Time: 0000 to 2359
No
No
NightSrvce Start
time
Enter Stop
time
Enter Exit
To activate/deactivate:
NightSrvce Time Control
To add or change start/stop time:
+
time
time
To activate/deactivate:
or
4
Drop Dial start day and
Drop Dial stop day and
or
Off On
Type start day and
+ Type stop day and
4
Issue 1
June 1997
Page 4-350
Enter Exit