Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 780

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Memory Card
Restore
Use this procedure to restore system conditions that were backed up onto a
translation memory card. The information in a backup file on the translation card is
copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
A previously stored set of system conditions is preferred over the current
set.
The processor module is replaced.
After a System Erase (frigid start) has been performed.
The system software has been reinstalled.
The Inspect feature (Inspct or
backup files on the memory card prior to initiating the restore procedure. The
attributes included on the Inspect screen are the filename, the time and day of the
file creation/update, the location of the system programming port, and information
about the system software release from which the backup was made.
If any type of programming is taking place at another extension when you begin
the restore procedure, the restore is canceled and the number of the first busy
extension appears on the screen. Repeat the restore procedure when the busy
extension becomes idle.
If a line is busy (incoming call or active call) when you begin the restore
procedure, the restore is canceled and the number of the first active line appears
on the screen. Repeat the restore procedure when the line becomes idle.
Also see ''Restore Messages''
the restore procedure.
Summary: Restore
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
To program weekly backup:
Insert memory card
Type day and time
) is available to view the attributes of the
for information about errors that may occur during
System Manager
All
System Forced Idle
Not applicable
Not applicable
Not applicable
   
  
4
4
Issue 1
June 1997
Page 4-373
+