System Operator Positions - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures

System Operator Positions

Console/Display Instructions
Continue with additional entries or go to Step 10.

Select .
Next
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit
System Operator Positions
A system operator position, for a Queued Call Console (QCC) operator or a
Direct-Line Console (DLC) operator, should be programmed before you program
lines or trunks.
QCC Operator Position
The QCC operator position is available only for Hybrid/PBX systems. The DLC
operator position is available in any mode and must be programmed if you have
Call Management Systems connected to any operator extension jacks. For
detailed programming procedures see
Procedures''.
This procedure applies to Hybrid/PBX systems only.
NOTE: NOTE: NOTE:
If you want to add or remove QCC operator positions, the following
conditions apply:
Additional Information
Return to Step 7. The next DSS Page
Button will be displayed on Line 1.
If other QCC positions remain in your system, the primary QCC
operator position cannot be removed.
When QCC operator positions are added, the primary QCC operator
position should be the first one added.
If QCC operator positions are being removed, the primary QCC
operator position must be the last one removed.
4
4
Chapter 3, ''Common Administrative
Issue 1
June 1997
Page 4-24
PC