Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 118

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Using SPM
If the backup file you select is a 4.0 backup, it can not be converted and the
following message appears:
File has already been converted.
Press Enter to continue.
Press
procedure.
If the backup file you select can be converted, go to Step 6.
Observe the updated file selection screen and press

Please select file name
to convert from
then press Enter
N: FILENAME.XXX
Press ESC to abort.
If converting from Release 1.0 or 1.1, select the CONVERT TO release. To con-

vert from Release 1.2, 2.0, or 2.1 go to Step 7.
Please enter your
CONVERT TO release
and press ENTER.
1.2i
2.0
3.0
Enter number: x.x
The screen below appears when converting from Release 1.0 or 1.1.
Follow the instructions for a floppy or a hard disk.

If the CONVERT TO file will be saved to a floppy disk, go to Step 8.
If the CONVERT TO file will be saved to the hard disk, go to Step 9.
to select another filename, or press
FILENAME.XXX =the backup filename
selected in Step 4
N = drive
,
1.4i
2.1
4.0/5.0
All characters must be entered as they
appear on the screen, including the
decimal point.
Issue 1
June 1997
Page 2-34
to abort the convert
.