Digit Absorption - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Automatic Route Selection
Console Display/Instructions
Enter the restriction level ( n = 0 to 6).

ARS Table xx Route x:
Enter restriction level
(0-6)
Backspace
Exit
Continue to enter FRL for another pool route or go to Step 5.

Select .
Next
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit

Digit Absorption

Use this procedure to specify how many of the digits dialed (0 through 11) by the
caller should be absorbed (not sent to the telephone company's central office) by
the system when a call is made on an identified route.
Entries of 1 through 11 indicate that the system should not send the specified
number of digits, starting with the first digit dialed by the user after the dial-out
code.
Digit absorption is assigned to Tables 1 through 18.
NOTE: NOTE: NOTE:
Pool routes must be programmed before you assign digit absorption.
Summary: Digit Absorption
Programmable by
Mode
Idle Condition
Planning Form
Additional Information
xx = table number entered in Step 1
Next
Dial or type [ n ].
Enter
System Manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
x = route number entered in Step 1
Return to Step 3. The next route will be
displayed on Line 1.
4
4
Issue 1
June 1997
Page 4-330
PC
Ã