Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 93

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Installing the SPM Software
Initializing the SPM Software
To run correctly, the DOS version of SPM requires certain information
(transmission speed, type of monitor, and so on). You need to supply this
information only once, the first time you run SPM.
The information you provide during the initialization process is written to the SPM
configuration file (ams.cfg). If you need to change this information at some later
time, you can do so in either of the following ways:
Use any of the options in
Edit the ams.cfg file. (If you are unsure about editing the file, you can
remove it. You are prompted to reinitialize the next time you invoke SPM.
The file is created at that time.)
NOTE: NOTE: NOTE:
The
default setting, or
Escape-to-Shell feature of SPM, activated by pressing
DEBUG on, you must edit the ams.cfg file; it is not part of the initialization
process. The DEBUG attribute is for use by qualified service personnel
only.
Table 2-1.
Option
spm -com1
spm -com2
spm -s1200
spm -s2400
spm -color
spm -mono
spm -1 english
spm -1 french
spm -1 spanish
Follow the steps below to perform the SPM initialization.
Type and press
spm

attribute is also specified in ams.cfg as
DEBUG
DEBUG=1
SPM Configuration File (ams.cfg) Options
Use
Specifies COM1 as the serial communications port
used by SPM
Specifies COM2 as the serial communications port
used by SPM
Specifies modem speed of 1200 bps
Specifies modem speed of 2400 bps
Specifies color monitor
Specifies monochrome monitor
Specifies English as the PC language
Specifies French as the PC language
Specifies Spanish as the PC language
to display the SPM Welcome screen shown in Step 2.
Make your entry at the
2
Table 2-1 to change the information in ams.cfg.
(on). This attribute is used to enable the
prompt if your PC has a hard disk.
C:>
Issue 1
June 1997
Page 2-9
(off), the
DEBUG=O
+ . To turn