Telnet-Peer-Stack-Unit - Dell S4810 Reference Manual

Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.2.1.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
Example
Dell(conf)#do telnet vrf vrf1 10.10.10.2

telnet-peer-stack-unit

Open a Telnet connection to the peer stack unit.
S4810
Syntax
telnet-peer-stack-unit
Defaults Not configured.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
158
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810. Added support for source-
interface for link-local IPv6 addressing.
Introduced on the Z9000.
Introduced on the E-Series ExaScale (IPv6). Increased the
number of VLANs on ExaScale to 4094 (was 2094).
Introduced on the E-Series ExaScale (IPv4).
Introduced VRF.
Introduced on the S-Series.
Introduced on the C-Series and added support for IPv6
address on the E-Series only.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Control and Monitoring