Isdp Holdtime; Isdp Timer; Isdp Advertise-V - NETGEAR ProSafe GSM7228PS Cli Manual

isdp holdtime

This command configures the hold time for ISDP packets that the switch transmits. The hold time
specifies how long a receiving device should store information sent in the ISDP packet before
discarding it. The range is given in seconds.
Default 180 seconds
Format
isdp holdtime <10-255>
Mode Global Config

isdp timer

This command sets the period of time between sending new ISDP packets. The range is given in
seconds.
Default 30 seconds
Format
isdp timer <5-254>
Mode Global Config

isdp advertise-v2

This command enables the sending of ISDP version 2 packets from the device.
Default Enabled
Format
isdp advertise-v2
Mode Global Config
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
Format
no isdp advertise-v2
Mode Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-194