Ipv6 Multicast Zapping - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

IP Multicast Switching Commands

ipv6 multicast zapping

Enables or disables MLD zapping on the specified VLAN or on the system if no VLAN is specified.

ipv6 multicast [vlan vid] zapping [{enable | disable}]

Syntax Definitions

enable | disable

Platforms Supported

OmniSwitch 6250

Usage Guidelines

If the MLD zapping is already enabled on the system, then the VLAN configuration will override the

system's configuration.

MLD zapping refers to processing membership and source filter removals immediately and not wait-

ing for the protocol's specified time period. This mode facilitates IP TV applications looking for quick

changes between IP multicast groups.

You can also restore the MLD zapping to its default (i.e., disabled) setting on the system if no VLAN

is specified, by using only ipv6 multicast zapping (e.g., ipv6 multicast zapping).

You can also restore the MLD zapping to its default (i.e., disabled) setting on the specified VLAN, by

using only ipv6 multicast vlan vid zapping (e.g., ipv6 multicast vlan 2 zapping).

-> ipv6 multicast zapping enable

-> ipv6 multicast zapping disable

-> ipv6 multicast zapping

-> ipv6 multicast vlan 2 zapping enable

-> ipv6 multicast vlan 2 zapping disable

-> ipv6 multicast vlan 2 zapping

Release History

Release 6.6.1; command was introduced.

OmniSwitch 6250 CLI Reference Guide

VLAN on which to apply the configuration.

Enable MLD zapping.

Disable MLD zapping.

November 2009