Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2168

Complete Software Guide for Junos
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
2064
®
OS for EX Series Ethernet Switches, Release 10.4
[edit protocols ospf3 realm (ipv4-unicast | ipv4-multicast | ipv6-multicast) area area-id],
[edit routing-instances routing-instance-name protocols (ospf | ospf3) area area-id],
[edit routing-instances routing-instance-name protocols ospf3 realm (ipv4-unicast |
ipv4-multicast | ipv6-multicast) area area-id]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 9.0 for EX Series switches.
Support for the topology statement introduced in Junos OS Release 9.0.
Support for the statement introduced in Junos OS Release 9.0 for EX Series
topology
switches.
Support for the statement introduced in Junos OS Release 9.2.
realm
Support for the realm statement introduced in Junos OS Release 9.2 for EX Series
switches.
Support for the
no-interface-state-traps
This statement is supported only for OSPFv2.
Enable OSPF routing on a routing device interface.
You must include at least one
on the routing device.
interface-name —Name of the interface. Specify the interface by IP address or interface
name for OSPFv2, or only the interface name for OSPFv3. Using both the interface
name and IP address of the same interface produces an invalid configuration. To
configure all interfaces, you can specify
produces an invalid configuration. For details about specifying interfaces, see interface
naming in the Junos OS Network Interfaces Configuration Guide.
NOTE: For nonbroadcast interfaces, specify the IP address of the
nonbroadcast interface as
The remaining statements are explained separately.
NOTE: You cannot run both OSPF and
two Juniper Networks routing devices.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
neighbor
Minimum OSPF Configuration
Configuring Multitopology Routing in OSPF
Configuring Multiple Address Families for OSPFv3
statement introduced in Junos OS Release 10.3.
statement in the configuration to enable OSPF
interface
. Specifying a particular interface and
all
interface-name .
ethernet-tcc
Copyright © 2010, Juniper Networks, Inc.
all
encapsulation between