Show Isis Authentication; Table 301: Show Isis Authentication Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

show isis authentication

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Copyright © 2010, Juniper Networks, Inc.
show isis authentication
<brief | detail | extensive>
<instance instance-name>
<logical-system (all | logical-system-name)>
show isis authentication
<brief | detail | extensive>
<instance instance-name>
Command introduced in Junos OS Release 7.5.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Display information about Intermediate System-to-Intermediate System (IS-IS)
authentication.
none —Display information about IS-IS authentication.
—(Optional) Display the specified level of output.
brief | detail | extensive
—(Optional) Display IS-IS authentication for the specified routing
instance instance-name
instance.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show isis authentication on page 2328
Table 301 on page 2327 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.

Table 301: show isis authentication Output Fields

Field Name Field Description
Interface name.
Interface
IS-IS level.
Level
IS-IS Hello (IIH) packet authentication type.
IIH Auth
Complete sequence number authentication type.
CSN Auth
Partial sequence number authentication type.
PSN Auth
Layer 1 link-state PDU authentication type.
L1 LSP
Authentication
Chapter 80: Operational Commands for Layer 3 Protocols
—(Optional) Perform this operation on all logical
show isis authentication
2327