Monitoring Routing Information - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 282: Summary of Key RIP Routing Output Fields (continued)
Field Values
RIP Neighbors
Neighbor Name of the RIP neighbor.
State State of the RIP connection:
Source Address Local source address.
Destination Address Destination address.
Send Mode The mode of sending RIP messages.
Receive Mode The mode in which messages are received.
In Metric Value of the incoming metric configured for the RIP
neighbor.
Related
Documentation

Monitoring Routing Information

Purpose
Action
Meaning
Copyright © 2010, Juniper Networks, Inc.
or
Up Dn
Configuring a RIP Network (J-Web Procedure) on page 1917
Layer 3 Protocols Supported on EX Series Switches on page 17
Use the monitoring functionality to view the
To view the routing tables in the J-Web interface, select Monitor > Routing > Route
Information. Apply a filter or a combination of filters to view messages. You can use
filters to display relevant events.
To view the routing table in the CLI, enter the following commands in the CLI interface:
show route terse
show route detail
Table 283 on page 1940 describes the different filters, their functions, and the associated
actions.
Table 284 on page 1940 summarizes key output fields in the routing information display.
Chapter 78: Verifying Layer 3 Protocols Configuration
Additional Information
This value is the name of the interface on which
RIP is enabled. Click the name to see the details for
this neighbor.
(Down).
This value is the configured address of the interface
on which RIP is enabled.
This value is the configured address of the
immediate RIP adjacency.
routing table on the routing device.
inet.0
1939