Table 338: Igmp Snooping Configuration Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 338: IGMP Snooping Configuration Fields

Field
VLAN Name
Immediate Leave
Robust Count
Copyright © 2010, Juniper Networks, Inc.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
Click one:
2.
Add —Creates an IGMP snooping configuration for the VLAN.
—Modifies an IGMP snooping configuration for the VLAN.
Edit
Delete —Deletes a selected VLAN from the IGMP snooping configuration.
When you are adding or editing an IGMP snooping configuration, enter information as
described in Table 338 on page 2553
Click OK to apply changes to the configuration or click
3.
changes.
To disable IGMP snooping on a VLAN, select the VLAN from the list and click
Function
Specifies the VLAN on which to enable
IGMP snooping.
Immediately removes a multicast group
membership from an interface when it
receives a leave message from that
interface without waiting for any other
IGMP messages to be exchanged
(IGMPv2 only).
Specifies the number of timeout
intervals the switch waits before timing
out a multicast group.
Chapter 83: Configuring IGMP Snooping and Multicast
>
Commit Options Commit
Cancel to cancel without saving
Your Action
Select a VLAN from the list to add it to
the snooping configuration.
To enable the option, select the check
box.
To disable the option, clear the check
box.
Type a value.
. See Using the
.
Disable
2553