Show Route Receive-Protocol - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

show route receive-protocol

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Additional Information
Required Privilege
Level
List of Sample Output
Output Fields
Table 332: show route receive-protocol Output Fields
Field Name Field Description
Name of the routing table—for example,
routing-table-name
Number of destinations for which there are routes in the routing table.
number
destinations
Copyright © 2010, Juniper Networks, Inc.
show route receive-protocol protocol neighbor-address
<brief | detail | extensive | terse>
<logical-system (all | logical-system-name)
show route receive-protocol protocol neighbor-address
<brief | detail | extensive | terse>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Display the routing information as it was received through a particular neighbor using a
particular dynamic routing protocol.
brief | detail | extensive | terse
logical-system (all | logical-system-name)
systems or on a particular logical system.
—Protocol transmitting the route (
protocol neighbor-address
or ripng ) and address of the neighboring router from which the route entry was
received.
The output displays the selected routes and the attributes with which they were received,
but does not show the effects of import policy on the routing attributes.
view
show route receive-protocol bgp on page 2497
show route receive-protocol bgp extensive on page 2498
show route receive-protocol bgp extensive on page 2498
show route receive-protocol bgp detail (Layer 2 VPN) on page 2499
show route receive-protocol bgp extensive (Layer 2 VPN) on page 2499
show route receive-protocol bgp (Layer 3 VPN) on page 2500
show route receive-protocol bgp detail (Layer 3 VPN) on page 2500
show route receive-protocol bgp extensive (Layer 3 VPN) on page 2501
Table 332 on page 2495 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
Chapter 80: Operational Commands for Layer 3 Protocols
—(Optional) Display the specified level of output.
—(Optional) Perform this operation on all logical
.
inet.0
, , , ,
bgp dvmrp msdp pim rip
show route receive-protocol
Level of Output
All levels
All levels
2495
,