Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1690

Complete Software Guide for Junos
Step-by-Step
Procedure
Results
1586
®
OS for EX Series Ethernet Switches, Release 10.4
set interfaces ge-0/0/1 unit 0 family ethernet-switching vlan members lab
set interfaces xe-0/1/0 unit 0 family ethernet-switching port-mode trunk
set protocols mvrp interface xe-0/1/0.0
To configure access Switch B for MVRP:
Configure the finance VLAN:
1.
[edit]
user@Access-Switch-B# set vlans finance vlan-id 100
Configure the lab VLAN:
2.
[edit]
user@Access-Switch-B# set vlans lab vlan–id 200
Configure the sales VLAN:
3.
[edit]
user@Access-Switch-B# set vlans sales vlan–id 300
Configure an Ethernet interface as a member of the finance VLAN:
4.
[edit]
user@Access-Switch-B# set interfaces ge-0/0/0 unit 0 family ethernet-switching vlan
members finance
Configure an Ethernet interface as a member of the lab VLAN:
5.
[edit]
user@Access-Switch-B# set interfaces ge-0/0/1 unit 0 family ethernet-switching vlan
members lab
Configure a trunk interface:
6.
user@Access-Switch-B# set interfaces xe-0/1/0 unit 0 family ethernet-switching trunk
Enable MVRP on the trunk interface:
7.
[edit]
user@Access-Switch-B# set protocols mvrp xe-0/1/0.0
NOTE: As we recommend as a best practice, default MVRP timers are
used in this example. The default values associated with each MVRP
timer are: 200 ms for the join timer, 1000 ms for the leave timer, and
10000 ms for the leaveall timer. Modifying timers to inappropriate values
might cause an imbalance in the operation of MVRP.
Check the results of the configuration:
[edit]
user@Access-Switch-B# show
interfaces {
ge-0/0/0 {
unit 0 {
family ethernet-switching {
vlan {
Copyright © 2010, Juniper Networks, Inc.