Table 233: Gvrp Timer Settings - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 233: GVRP Timer Settings

Field Function
Join Timer Specifies the maximum number of milliseconds the interface waits
before sending VLAN advertisements.
Leave Timer Specifies the number of milliseconds an interface waits after
receiving a leave message before the interface leaves the VLAN
specified in the message.
Leave All Timer Specifies the interval in milliseconds at which Leave All messages
are sent on interfaces. Leave All messages help to maintain current
GVRP VLAN membership information in the network.
Disable GVRP Disables GVRP on all interfaces.
Copyright © 2010, Juniper Networks, Inc.
GVRP-enabled switch. The switch adds trunk interface 1 to the sales VLAN if the sales
VLAN already exists on the switch.
As individual interfaces become active and send requests to join a VLAN, the VLAN
configuration is updated and propagated among the switches. Limiting the VLAN
configuration to active participants reduces the network overhead. GVRP also provides
the benefit of pruning VLANs to limit the scope of broadcast, unknown unicast, and
multicast (BUM) traffic to interested network devices only.
To configure GVRP using the J-Web interface:
Select
Configure > Switching > GVRP
1.
are listed.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select Commit Options > Commit. See Using the
Commit Options to Commit Configuration Changes for details about all
commit options.
To enable GVRP on an interface, click
2.
from the
Interface Out of GVRP
To modify GVRP timers, click
3.
the interface, enter information as described in Table 233 on page 1609.
Click to apply changes to the configuration or click
OK
4.
changes.
To disable an interface, select the interface and click
Chapter 65: Configuring Bridging and VLANs
. Interfaces on which GVRP has been enabled
. Click the arrow key to move the interface
Add
list to the
Interface under GVRP
. For modifying GVRP Timer settings for
Global Settings
Cancel
Disable Port
Your Action
Type a number.
Type a number.
Type a number.
To disable GVRP, select the check
box.
To enable GVRP, clear the check
box.
list, and click .
OK
to cancel without saving
.
1609