Table 277: Static Routing Configuration Summary
Field
Default Route
Default Route
Static Routes
Copyright © 2010, Juniper Networks, Inc.
To configure static routes:
Select
>
Configure
Routing
1.
of the configured routes.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
Click one:
2.
Add
—To configure a route. Enter information into the routing page as described in
Table 277 on page 1923.
—To modify an existing route. Enter information into the routing page as
Edit
described in Table 277 on page 1923.
Delete
—To delete an existing route.
Function
Specifies the default gateway for the
switch.
NOTE: IPv6 is not supported on
EX2200 and EX4500 switches.
Chapter 77: Configuring Layer 3 Protocols
>
. The Static Routing page displays details
Static Routing
Commit Options
Your Action
To specify an IPv4 address:
1.
Select
2. Type an IP address—for example,
10.10.10.10
3. Enter the subnet mask or address prefix.
For example, 24 bits represents
255.255.255.0
To specify an IPv6 address:
1.
Select
2. Type an IP address—
for example,
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
>
. See Using the
Commit
.
IPv4
.
.
.
IPv6
.
1923